Huawei SUN2000-3KTL-M1 User Manual

9 Handling the Inverter
9.1 Removing the SUN2000
NO TICE
Before removing the SUN2000, power o the AC and DC (batteries).
Perform the following operations to remove the SUN2000:
1. Disconnect all cables from the SUN2000, including RS485 communications
cables, DC input power cables, AC output power cables, and PGND cables.
2. Remove the SUN2000 from the mounting bracket.
3. Remove the mounting bracket.
9.2 Packing the SUN2000
● If the original packing materials are available, put the SUN2000 inside them
and then seal them by using adhesive tape.
● If the original packing materials are not available, put the SUN2000 inside a
suitable cardboard box and seal it properly.
9.3 Disposing of the SUN2000
If the SUN2000 service life expires, dispose of it according to the local disposal
rules for electrical equipment waste.
SUN2000-(3KTL-10KTL)-M1
User Manual 9 Handling the Inverter
Issue 02 (2020-11-20) Copyright © Huawei Technologies Co., Ltd. 96

Huawei SUN2000-3KTL-M1 Specifications

General

Model	SUN2000-3KTL-M1
Type	String Inverter
Max. DC Input Voltage	600 V
MPPT Voltage Range	90 V - 560 V
Rated AC Output Power	3000 W
Max. AC Output Power	3300 W
Nominal AC Voltage	220 V / 230 V / 240 V
AC Voltage Range	180 V - 280 V
AC Output Frequency	50 Hz / 60 Hz
Max. Efficiency	98.6%
MPPT Trackers	2
DC Inputs per MPPT	1
Max. Input Current per MPPT	11 A
Operating Temperature Range	-25°C to +60°C
Cooling Method	Natural Convection
Protection Degree	IP65
Max. DC Input Power	4500 W
Communication	RS485
Dimensions (W x H x D)	365 mm x 365 mm x 156 mm