Huawei TE40 Administrator's Guide

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
13 Feature Configuration
Issue 01 (2013-09-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
146
Parameter
Description
Setting
each site is switched along with the
video. All sites in a conference can
share presentations simultaneously.
NOTE
When connected to an IMS network, the
endpoint cannot share a presentation in Live
mode.
Presentation
sharing mode

Auto: The endpoint automatically
shares presentations along with
videos. This parameter can be set to
Auto only when Presentation mode
is set to Live.

Manual: You must manually share
presentations by using the remote
control.
The default value is
Manual.
Presentation
plug-and-share
Specifies whether your site
automatically shares presentations with
remote sites once presentation input is
detected.
The default value is Disable.
Conference line
type
Specifies the type of line used during a
conference.
If you select Auto and your endpoint has
registered with a network gatekeeper
(GK) server, your endpoint
preferentially uses H.323 to initiate a
conference.
The default value is Auto.
Conference
bandwidth
Specifies the transmission bandwidth for
a conference.
The default value is Normal.
Dynamic
bandwidth
Specifies whether the endpoint
implements the following if the packet
loss rate increases due to insufficient
network bandwidth: automatically
decreases the conference bandwidth
until packet loss does not occur
constantly or the conference bandwidth
is decreased to 64 kbit/s. If constant
packet loss is detected, the endpoint can
dynamically adjust bandwidth to recover
stable conference quality within 1
minute.
This parameter is not
selected by default.

When the network is
running within normal
parameters, retain the
default value.

When the network is not
running within normal
parameters, select this
parameter.
reserved
presentation
bandwidth
Disable this parameter if your site is not
going to send or receive presentations
during a conference and the Received
value for Presentation bandwidth
[frame rate] is not -.
If this parameter is disabled, the
Received value for Presentation
bandwidth [frame rate] restores to -
The default value is Enable.

Huawei TE40 Specifications

General

Brand	Huawei
Model	TE40
Category	Conference System
Language	English