HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
The Call screen is displayed.
Step 2 In the text box, enter the access number of the authentication conference.
Step 3 Press or on the remote control.
If the authentication conference is password-protected, the endpoint plays an interactive voice
response (IVR), prompting you to enter the password. If the conference is not
password-protected, you can join the conference after selecting the desired language.
----End
6.4 Joining an HD-Video Conference over an IMS
Network
The endpoint can join an HD video conference over an IMS network.
Background
Borne by the standard IP protocol, IMS uses VoIP applications based on the standard SIP
applications of the 3GPP to provide fixed and mobile multimedia services for operators.
Integrating MCUs can enhance the functionality of the Huawei IMS HD videoconferencing
solution.
Prerequisites
You have obtained the required authentication information from the IMS administrator:
unified access number, conference ID, and conference password.
Endpoint users can obtain the required authentication information allocated by the IMS through emails,
text messages, notices, or other methods.
Procedure
Step 1 Register the endpoint with the network where the IMS is located.
1. Choose Advanced > Settings > Network > IP > SIP.
2. Set the parameters for interworking with the IMS described in Table 6-2.
Table 6-2 SIP parameters
Specifies whether your endpoint registers
with an IMS server.
Only endpoints that have registered with
IMS servers can join the IMS network.
An endpoint that registers with an IMS
server can place calls to remote sites
using their IP addresses or site numbers
if the remote sites also register with IMS
To Next Page
Loading...
Need help?
General
