Huawei TE40 Administrator's Guide

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
13 Feature Configuration
Issue 01 (2013-09-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
147
Parameter
Description
Setting
when you rejoin the conference.
NOTE
To view the Presentation bandwidth
[frame rate] value, choose Advanced >
Diagnostics > Status > Conference.
Preferred IP
protocol
Specifies the protocol that IP sites
preferentially use.
When Line type is set to Auto for IP
sites, your endpoint uses this protocol to
call the IP sites.
The default value is H.323.
Face detection
Specifies whether to perform HD
encoding and decoding to improve face
recognition video quality.
You can increase the video sharpness by
enabling this parameter in low
bandwidths.
The default value is Disable.
Site called
during startup
Specifies the site that your endpoint
automatically calls when it starts.

None: The endpoint does not call any
sites.

Select site from address book: The
endpoint displays the address book
screen from which you can specify
the site you want your endpoint to
call after its startup.
You can proceed to set Call times only
after you set this parameter.
The default value is None.
Call times
Specifies the maximum number of
attempts your endpoint calls a specified
site after startup.
The default value is 1.
The maximum value is 10.
If you set this parameter to
0, your endpoint does not
call the specified site after
startup.
13.4 Setting SNMP Parameters
To enable the videoconferencing network management system to manage your endpoint,
configure the Simple Network Management Protocol (SNMP) settings.
Your endpoint communicates with and is remotely managed by the videoconferencing
network management system using SNMP. The videoconferencing network management
system implements the following:

Configures endpoint settings, including the H.323, SIP.

Huawei TE40 Specifications

General

Brand	Huawei
Model	TE40
Category	Conference System
Language	English