Huawei TE40 Administrator's Guide

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
13 Feature Configuration
Issue 01 (2013-09-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
148

Checks endpoint alarms.

Backs up and restores endpoint settings.

Upgrades the endpoint online.
On the endpoint web interface, choose System Settings > Network and click the SNMP
Settings tab. Set the SNMP parameters described in Table 13-4.
Table 13-4 SNMP parameters
Parameter
Description
Setting
Enable
SNMP
Specifies whether the videoconferencing
network management system uses SNMP
to manage your endpoint.
NOTE
If you set this parameter to Enable, you must
set other SNMP parameters.
The default value is Enable.
Get
community
name
Specifies the read-only SNMP
community name.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
Set
community
name
Specifies the read-write SNMP
community name.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
Trap
community
name
Specifies the trap community name.
The default value is
Change_Me.
Set this parameter to the value
defined on the
videoconferencing network
management system.
The value is a string of 1 to 32
characters.
Trap server
address 1
Trap server
address 2
Trap server
address 3
Specify the IP address to which your
endpoint sends traps, namely, the IP
address of the computer where the
videoconferencing network management
system server is installed.
NOTE
A trap is an unrequested message that a
managed device (for example, an endpoint)
sends to a trap server (for example, the SMC)
No default value is set for this
parameter.
You can leave this parameter
blank.

Huawei TE40 Specifications

General

Brand	Huawei
Model	TE40
Category	Conference System
Language	English