Huawei TE40 Administrator's Guide

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
13 Feature Configuration
Issue 01 (2013-09-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
149
Parameter
Description
Setting
to report urgent and important events.
Trap version
Version of the traps that the endpoint
sends to the videoconferencing network
management system through SNMP.
The default value is v3 trap.
Trap timeout
time
Specifies the timeout interval for traps,
in seconds.
This parameter is available only when
Trap version is set to v2 inform or v3
inform.
The default value is 1.
Trap retry
times
Specifies the number of retry attempts
for sending a trap.
This parameter is available only when
Trap version is set to v2 inform or v3
inform.
The default value is 5.
User name
Specifies the user name for sending
traps.
This parameter is available only when
Trap version is set to v3 trap or v3
inform.
The default value is trapinit.
ID
Specifies the engine ID for the
videoconferencing network management
system. This ID is used only when your
endpoint sends traps of version 3.
This parameter is available only when
Trap version is set to v3 trap or v3
inform.
Set this parameter to the ID
defined on the
videoconferencing network
management system.
Authenticati
on protocol
Authenticati
on password
Specify the authentication mode and
password that your endpoint uses to send
traps to the videoconferencing network
management system through SNMP.
This parameter is available only when
Trap version is set to v3 trap or v3
inform.
The default value of
Authentication protocol is
MD5.
Set Authentication password
to the password defined on the
videoconferencing network
management system.
If the two passwords are not the
same, authentication fails.
Encryption
protocol
Encryption
password
Specify the encryption protocol and
password that your endpoint uses to send
traps to the videoconferencing network
management system through SNMP.
If you select No encryption for
Encryption protocol, traps are
transmitted using plaintext.
This parameter is available only when
Trap version is set to v3 trap or v3
inform.
The default value of
Encryption protocol is DES.
Set Encryption password to a
string of 1 to 32 characters,
which contains letters, digits,
and special characters.

Huawei TE40 Specifications

General

Brand	Huawei
Model	TE40
Category	Conference System
Language	English