Hypertherm ArcGlide THC

ArcGlide THC Instruction Manual 806450 233
4 – Maintenance
J8 ENABLE/DISABLE switch
Pin No. Signal
1 Station enable
2 Common
J9 UP/DOWN switch
Pin No. Signal
1 Up switch
2 Common
3 Down switch
4 Not connected
J10 Lifter I/O cable (red)
Pin No. Signal Pin No. Signal
1 Motor + 2 Motor -
3 Brake - 4 Common -
5 Power +24 VDC 6 Ohmic contact sense common
7 Ohmic contact sense 8 Ohmic contact sense bias -12 VDC
9 Encoder common 10 +5 V Station active
11 Encoder input B - 12 Encoder input B +
13 Encoder input A - 14 Encoder input A +
15 Field common 16 Change consumable switch +
17 Lifter down switch + 18 Lifter up switch +
19 Breakaway switch + 20 Upper limit switch +
21 Lower limit switch + 22 Not connected
23 Common 24 Not connected