Hypertherm ArcGlide THC

ArcGlide THC Instruction Manual 806450 269
Appendix B
ArcGlide THC Serial Communication Installation
Introduction
This appendix describes the features of an ArcGlide THC that are unique to systems in which ArcGlide communication
uses the RS-422 serial protocol and in which the ArcGlide:
 Replaces a Command THC
 Is installed in new system using Command THC serial communication
For more information on the ArcGlide serial protocol, see ArcGlide THC Serial Communication Protocol on page 249.
Refer to the manufacturers’ instruction manuals for specific information about making serial, I/O, and power connections
to the CNC and plasma system in your plasma cutting machine.
Kit 228846 (Command THC replacement)
Part number Description Quantity
223253 Plasma I/O and CNC I/O to THC control module cable with
serial split (Z adapter)
1
223260 Plasma board adapter cable 1