EasyManuals Logo
Home>Hypertherm>Cutter>HyPerformance Plasma HPR800XD

Hypertherm HyPerformance Plasma HPR800XD User Manual

Hypertherm HyPerformance Plasma HPR800XD
366 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
InstallatIon
3-28 HPR800XD Auto Gas 806500
8
Chiller interface power cable
Cable signal list – primary power supply to chiller interface
Power supply end Chiller interface end
Pin No.
Wire
color
Description Pin No.
1
Red/
black
240 VAC-hot 1
2 Red 240 VAC-return 2
3 Shield Ground 3
15 White Solenoid V1- return 15
11 Black Solenoid V1- hot 11
6 Shield Ground 6
Part no. Length
123979 1.5 m (5 ft)
123980 3 m (10 ft)
123981 4.5 m (15 ft)
Primary power supply to chiller interface console
8
End with sockets to
chiller interface
Note: The inductor on the pump motor drive board makes a noise during operation that has been
described as a “hum”, “sing”, and “click”. This is normal and can be disregarded.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm HyPerformance Plasma HPR800XD and is the answer not in the manual?

Hypertherm HyPerformance Plasma HPR800XD Specifications

General IconGeneral
BrandHypertherm
ModelHyPerformance Plasma HPR800XD
CategoryCutter
LanguageEnglish

Related product manuals