Serial Communication Programmer Reference Guide
4 810400 Reference Guide Powermax65/85/105 SYNC
Read the plasma power supply settings that are permitted for the installed cartridge .......... 26
0x3001 (permitted operating mode setting)......................................................................... 26
0x3002, 0x3003 (permitted minimum and maximum output current (A) settings)...... 26
0x3004, 0x3005 (permitted minimum and maximum gas pressure settings)............... 26
Example request and response................................................................................................ 27
Write operating settings and put the plasma power supply into remote control mode.......... 28
0x3080 (operating mode setting) ........................................................................................... 28
0x3081 (output current (A) setting)........................................................................................ 28
0x3082 (gas pressure setting) ................................................................................................ 29
Example request and response................................................................................................ 29
Remote control mode indicator on the plasma power supply .......................................... 30
Do a check for an active fault............................................................................................................... 30
0x301A (active fault code)........................................................................................................ 30
Example request and response................................................................................................ 31
Fault code list............................................................................................................................... 32
Start and stop a gas test....................................................................................................................... 36
0x3180 (coil: gas test)............................................................................................................... 36
Example request and response................................................................................................ 37
Do a quick restart or clear fault code 0-50-0 .................................................................................. 38
0x308E, 0x308F (quick restart with approval)..................................................................... 38
Example request and response................................................................................................ 39
Exit remote control mode ...................................................................................................................... 40
Example request and response................................................................................................ 40
Get data from the plasma power supply ....................................................................................................... 41
Read the plasma power supply settings............................................................................................ 41
0x3010 (operating mode).......................................................................................................... 41
0x3011 (output current (A) setting)........................................................................................ 41
0x3012 (gas pressure setting)................................................................................................. 42
Example request and response................................................................................................ 42
Read the actual output of the plasma power supply ...................................................................... 43
0x3018 (actual output current)................................................................................................ 43
0x3019 (actual gas pressure) .................................................................................................. 43
Example request and response................................................................................................ 43
Read the total cut counts for this plasma power supply................................................................ 44
0x3028 (total number of torch starts – bytes 1 and 0)...................................................... 44
0x3029 (total number of starts – bytes 3 and 2) ................................................................ 45
0x302A (cumulative pilot arc time – bytes 1 and 0)........................................................... 45
0x302B (cumulative pilot arc time – bytes 3 and 2)........................................................... 45
To Next Page
Loading...
