Hypertherm Powermax65 SYNC - Read the Total Cut Counts for the Installed Cartridge; 0 X3040 (Total Number of Starts); 0 X3041 (Cumulative Pilot Arc Time); 0 X3042 (Total Number of Arc Transfers)

Serial Communication Programmer Reference Guide
50 810400 Reference Guide Powermax65/85/105 SYNC
Read the total cut counts for the installed cartridge
To read the total cut counts for the installed cartridge, the CNC reads the values in the following
registers:
 0x3040 (total number of starts)
 0x3041 (cumulative pilot arc time)
 0x3042 (total number of arc transfers)
 0x3043 (cumulative arc transfer time)
0x3040 (total number of starts)
0x3041 (cumulative pilot arc time)
0x3042 (total number of arc transfers)
Description: Reads the hexadecimal value for the total number of pilot arc starts that the
cartridge has done in its life.
Convert the hexadecimal value to decimal.
Encoding or scaling: 16-bit unsigned binary number
Unit: N/A
Function (hex): 04 (Read Registers)
Description: Reads the hexadecimal value for the cumulative pilot arc time in seconds that the
cartridge has had in its life.
Convert the hexadecimal value to decimal.
Encoding or scaling: 16-bit unsigned binary number
Unit: N/A
Function (hex): 04 (Read Registers)
Description: Reads the hexadecimal value for the total number of arc transfers that the cartridge
has done in its life.
Convert the hexadecimal value to decimal.
Encoding or scaling: 16-bit unsigned binary number
Unit: N/A
Function (hex): 04 (Read Registers)