1-7
Scanner Assembly
032-0330-EN Rev K
27.
29
28
27
Unlatch panel cover by pulling cover forward
slightly, then swinging cover outward to
remove.
28. Feed LEMO connector through hub and plug
into panel. Rotate red dot on connector to the
3 o’clock position. Slide connector into
receptor until it snaps in place.
29. Feed green network connector through the
hub and plug connector into panel.
30. Snap panel cover into place. Receptor
assembly cover can remain off for GeoCal
adjustments.
31.
33
3/32
32
Locate X-ray source assembly and remove
from packing material.
32. Place assembly on clean surface. Remove
and set aside the magnetic mounted X-Ray
source window panel from the cover.
33. Remove cover mounting screws from top and
bottom of scanner (quantity 4 outer cover and
4 inner source cover).
34.
34
Detach outer cover ONLY.
To Next Page
Loading...
