3-18
i-CAT FLX Installation Manual
032-0330-EN Rev K
NOTE: The Legacy Practice Management Interface and the DEXIS i-CAT FLX Server
Plugin cannot be installed on a computer at the same time.
b. Click Install.
c. Click Yes on the confirmation dialog. The discovery service prepares for installation. If the
required .NET framework and Visual C++ packages are not installed, the required files will
be loaded. This may take a few minutes.
4. For Integration Services installation:
a. On Welcome screen, click Next.
b. On Select Installation Folder screen, use the default location. Click Next.
c. On Confirm Installation screen, click Next. Installation will start and a progress bar is
displayed.
d. When installation completes, click Close on the Installation Complete screen.
5. If PACS Storage Service was selected to be installed:
NOTE: For sites using a PACS, additional setup is required. After all software is loaded,
see Configure SmartScan STUDIO PACS Modules (Optional) (page 3-26) for additional
setup instructions.
a. On SmartScan STUDIO PACS Storage screen, click Next.
b. On the Ready to Install window, click Install. The software installs and a progress bar is
displayed.
c. When Complete window is displayed, click Finish.
6. If Data Utility was selected to be installed:
a. On the Data Utility window, click Next.
b. On the Ready to Install window, click Install. The software installs and a progress bar is
displayed.
c. When Complete window is displayed, click Finish.
NOTE: For sites using Data Utility, additional setup is required. After all software is loaded,
see i-CAT FLX Technical Guide for additional setup instructions.
7. If the Patient Data Utility was selected to be installed:
a. On the Patient Data Utility window, click Next.
b. On the Ready to Install window, click Install. The software installs and a progress bar is
displayed.
c. When Complete window is displayed, click Finish.
NOTE: For sites using Paient Data Utility, additional setup is required. After all software is
loaded, see i-CAT FLX Technical Guide for additional setup instructions.
8. If the Legacy Practice Management Interface was selected to be installed:
a. On Welcome screen, click Next.
b. On Select Installation Folder screen, use the default location. Click Next.
c. On Confirm Installation screen, click Next. Installation will start and a progress bar is
displayed.
d. When installation completes, click Close on the Installation Complete screen.
To Next Page
Loading...
