i-CAT FLX - Page 92

A-6
i-CAT FLX Installation Manual
032-0330-EN Rev K
9.
9
At top of operator control box, slide clip away from tab
so that tab can be pressed down to loosen side panel
(both sides).
10.
10
Lift side panel (tab end) upward and remove from
operator control box (both sides).
11.
12
There are four outer mounting rings on the operator
control box base. These rings can be pre-drilled or
punctured with a screw during mounting.
12. Position operator control box on wall over hole and
mount with wall mounting hardware (four corners).
Replace operator control box side panels and re-insert
clips under tabs (both sides).