150
NAS Switch Status Parameters:
The port's current administrative state. Refer to NAS Admin State for a description of possible
values.
The current state of the port. Refer to NAS Port State for a description of the individual states.
Auto-refresh: Check this box to refresh the page automatically. It will do so every 3 seconds.
Refresh: Click to refresh the page.
ACL Status
This section displays the ACL status for different ACL users. Each row displays the ACE that is defined. There will be a
conflict if a specific ACE is not applied to the hardware due to hardware limitations. The maximum number of ACEs is 512 on
each switch.
To Display the ACL status in the web interface:
Click Monitor / Security / Network / ACL Status
Check the Auto-Refresh check box to have the page automatically refresh every 3 seconds.
ACL Status Parameters:
Indicates the ingress port of the ACE. Possible values are:
All: The ACE will match any ingress port,
Port: The ACE will match a specific ingress port.
Indicates the frame type of the ACE. Possible values are:
Any: The ACE will match any frame type.
Etype: The ACE will match Ethernet Type Frames. Note that an Ether net Type based ACE will
not get matched by IP and ARP Frames.
ARP: The ACE will match ARP/RARP frames.
IPv4: The ACE will match all IPv4 Frames.
IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
To Next Page
Loading...