29
DHCP Server Pool
This page manages DHCP pools. According to the DHCP pool, the DCHP server will allocate IP addresses and deliver
configuration parameters to the DHCP client.
To configure DHCP Server Pool in the web interface:
Click Configuration / DHCP / Server / Pool
Click Add New Pool then create a new Pool on the switch.
Click Apply and click the Save icon in the upper right corner to save the settings or click Reset to cancel. The
Form will return to the previously saved settings.
DHCP Server Pool Parameters:
Add or delete pools. Adding a pool and giving a name is to create a new pool with
"default" configuration. If you want to configure all settings including type, IP subnet mask
and lease time, you can click the pool name to go into the configuration page.
Configure the pool name that accepts all printable characters, except white space. Click the
pool name to configure the detail settings of the pool.
Display which type the pool is. Network: The pool defines a pool of IP addresses to service
more than one DHCP client, or Host: The pool serves as a specific DHCP client identified by
client identifier or hardware address. If “-“is displayed, it means not defined.
Display network number of the DHCP address pool. If “-“is displayed it is not defined.
Display subnet mask of the DHCP address pool. If “-“is displayed it is not defined.
Displays lease time of the pool.
To Next Page
Loading...