Specify ARP Inspection is enabled on which ports. Only when both Global Mode and Port
Mode on a given port are enabled, ARP Inspection is enabled on this given port. Possible
modes are:
Enabled: Enable ARP Inspection operation.
Disabled: Disable ARP Inspection operation.
If you want to inspect the VLAN configuration, you have to enable the setting of "Check VLAN".
The default setting of "Check VLAN" is disabled. When the setting of "Check VLAN" is
disabled, the log type of ARP Inspection will refer to the port setting. And the setting of "Check
VLAN" is enabled, the log type of ARP Inspection will refer to the VLAN setting.
Possible setting of "Check VLAN" are:
Enabled: Enable check VLAN operation.
Disabled: Disable check VLAN operation.
Only the Global Mode and Port Mode on a given port are enabled, and the setting of "Check
VLAN" is disabled, the log type of ARP Inspection will refer to the port setting. There are log
types and possible types are:
None: Log denied entries.
Deny: Log denied entries.
Permit: Log permitted entries.
ALL: Log all entries.
To Next Page
Loading...