Table 4. SPCN Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
1011 8404 Processor unit VPD mismatch
1. Processor card
Location: U1.1–P1–C1
2. Primary I/O backplane
Location: U0.1–P1
1011 8409 VPD for processor card 1. Ensure that the processor
assembly(s) are the correct
type for the system and are
properly installed.
2. Processor card
Location: U1.1-P1-C1
1011 840A VPD +5 stuck high Ignore all location codes.
Go to MAP 1540 and run CEC
minimum configuration.
1011 840B VPD +5 stuck low Ignore all location codes.
Go to MAP 1540 and run CEC
minimum configuration.
1011 840C Memory DIMM misplugged Inspect system memory for proper
installation of DIMMs and memory
cards
1011 840D I/O type mismatch 1. Check cabling
2. Set the I/O type to 85. See
Power Control Network Utilities
Menu on page 389.
3. Primary I/O backplane
Location: U0.1-P1
1011 840E SPCN default configuration loaded 1. Check cabling
2. Set the I/O type to 85. See
Power Control Network Utilities
Menu on page 389.
3. Primary I/O backplane
Location: U0.1-P1
1011 840F I/O type not recognized 1. Check cabling
2. Set the I/O type to 85. See
Power Control Network Utilities
Menu on page 389.
3. Primary I/O backplane
Location: U0.1-P1
1011 8413 Invalid processor VPD Processor card
Location: U1.1-P1-C1
1011 8423 No processor VPD Processor card
Location: U1.1-P1-C1
1011 8430 V/S Comm cable not connected Check cabling
180 Service Guide
To Next Page
Loading...