IBM 7026-H80 - RS/6000 - 256 MB RAM - Page 200

Table 4. SPCN Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
1011 9103 Download initialize timeout Primary I/O backplane
Location: U0.1-P1
1011 9104 Download completion timeout Primary I/O backplane
Location: U0.1-P1
1011 9105 Load damaged timeout Primary I/O backplane
Location: U0.1-P1
1011 9109 Download failure Primary I/O backplane
Location: U0.1-P1
1011 9111 Network too large for service processor
1. Check for system firmware
update.
2. Call service support.
1011 9114 Firmware image corrupted 1. Reinstall system firmware
2. Primary I/O backplane
Location: U0.1-P1
1011 9116 SCPN communication with operator panel
failure
1. Primary I/O operator panel
Location: U0.1-L1
2. Primary I/O backplane
Location: U0.1-P1
1021 00AA SPCN firmware update started Information message
1021 1510 Power supply 1 power source failure 1. Check input power to power
supply
2. Secondary I/O power supply 1
Location: U0.2-V1
3. Secondary I/O backplane
Location: U0.2-P1
1021 1511 Power supply 1 fault 1. Secondary I/O power supply 1
Location: U0.2-V1
2. Secondary I/O backplane
Location: U0.2-P1
1021 1512 Power supply 1 non-power fault 1. Secondary I/O power supply 1
Location: U0.2-V1
2. Secondary I/O backplane
Location: U0.2-P1
1021 1513 Power supply 1 domain fault 1. Secondary I/O power supply 1
Location: U0.2-V1
2. Secondary I/O backplane
Location: U0.2-P1
1021 1514 Power supply 1 cooling fault 1. Secondary I/O power supply 1
Location: U0.2-V1
2. Secondary I/O backplane
Location: U0.2-P1
182 Service Guide