816f0a0c-2017xxxx An Over-Temperature Condition has been removed on the [PhysicalMemoryElementName] on
Subsystem [MemoryElementName]. (DIMM 23)
Explanation: This message is for the use case when an implementation has detected an Over Temperature Condition
for Memory that has been Removed.
May also be shown as 816f0a0c2017xxxx or 0x816f0a0c2017xxxx
Severity: Info
Alert Category: Critical - Temperature
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0147
SNMP Trap ID: 0
Automatically notify Support: No
User response: No action; information only.
816f0a0c-2018xxxx An Over-Temperature Condition has been removed on the [PhysicalMemoryElementName] on
Subsystem [MemoryElementName]. (DIMM 24)
Explanation: This message is for the use case when an implementation has detected an Over Temperature Condition
for Memory that has been Removed.
May also be shown as 816f0a0c2018xxxx or 0x816f0a0c2018xxxx
Severity: Info
Alert Category: Critical - Temperature
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0147
SNMP Trap ID: 0
Automatically notify Support: No
User response: No action; information only.
816f0a13-0301xxxx System [ComputerSystemElementName] has recovered from a Fatal Bus Error. (CPU 1 PECI)
Explanation: This message is for the use case when an implementation has detected that a system has recovered
from a Bus Fatal Error.
May also be shown as 816f0a130301xxxx or 0x816f0a130301xxxx
Severity: Info
Alert Category: Critical - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0245
SNMP Trap ID: 50
Automatically notify Support: No
User response:
1. (Trained technician only) Replace microprocessor n (see Removing a microprocessor and heat sink and Replacing
a microprocessor and heat sink).
2. If the problem persists and there is no other CPU with the same error indication, replace the system board.
3. (Trained technician only) Replace the system board (see Removing the system board and Replacing the system
board). (n = microprocessor number)
816f0a0c-2017xxxx • 816f0a13-0301xxxx
Appendix A. Integrated management module II (IMM2) error messages 663
To Next Page
Loading...
Need help?
General