Icom IC-910H - Page 9

7
2
PANEL DESCRIPTION
•Entersnumeral“1”whenenteringanoperating
frequency. (p. 23)
•Switches between VFO and memory mode.
(p. 40)
Entersnumeral“2”whenenteringanoperating
frequency. (p. 23)
•Entersnumeral“3”whenenteringanoperating
frequency. (p. 23)
•Switches betweenVFO A and B duringVFO
mode operation. (p. 21)
Entersnumeral“4”whenenteringanoperating
frequency. (p. 23)
Entersnumeral“5”whenenteringanoperating
frequency. (p. 23)
Entersnumeral“6”whenenteringanoperating
frequency. (p. 23)
Entersnumeral“7”whenenteringanoperating
frequency. (p. 23)
•Entersnumeral“8”whenenteringanoperating
frequency. (p. 23)
•Storesthedisplayedoperatingconditionsinto
MEMO PAD channel (p. 44)
•Entersnumeral“9”whenenteringanoperating
frequency. (p. 23)
•Re-callsthecontentsintheMEMOPADchan-
nel. (p. 44)
•Entersdecimalpoint“.”forenteringbelowthe
“MHz“digits when entering an operatingfre-
quency.
•Startsandcancelsscanningfunction.(p.46)
•TurnsOFFtheSUBbandfrequencyindication
during satellite operation. In this case, only the
MAIN band frequency can be tuned by rotating
the tuning dial. (p. 49)
•Entersnumeral“0”whenenteringanoperating
frequency. (p. 23)
•SwitchessweepfunctionforthebandscopeON
and OFF. (p. 29)
•TurnsOFFtheMAINbandfrequencyindication
during satellite operation. In this case, only the
SUB band frequency can be tuned by rotating
the tuning dial. (p. 49)
Enables operating frequency entering from the
keypad. See page 23 for details.
Equalizes the condition of the VFO A and B.
(p. 21)
Shows 10 Hz and 1 Hz digits of operating fre-
quency on both the MAIN and SUB bands while
pushing and holding. (p. 22)
Stores the set conditions into a memory channel.
(p. 41)
Clears stored contents of memory channel to be a
blank channel. (p. 43)
Transfers the contents of a memory channel into
either the VFO A or B. (p. 42)
Opens squelch for monitoring the operating or
transmit frequency, and the frequency indication
automatically changes to transmit frequency in
the case of duplex or split operation. (p. 34)
Starts and cancels tone scan when the repeater
tone or tone squelch is activated in FM (narrow)
operation. (p. 47)
Used to change memory channel during memo-
ry mode operation by rotating the tuning dial while
pushing and holding. (p. 40)
Switch Switch action when pushed Switch action when pushed for 1 sec.