33
6
MEMORY CHANNELS
■ Erasing/transferring bank contents
The bank contents of programmed memory channels can be
cleared or reassigned to another memory bank.
INFORMATION: Even if the memory bank contents are
cleared, the memory channel contents still remain pro-
grammed.
qSelect the desired bank contents to be transferred or
erased from the bank.
➥ Push [MR S.MW] to select memory mode.
➥ While pushing [BAND], rotate [R-DIAL] to select the
desired memory bank group.
➥ Rotate [R-DIAL] to select the bank channel.
wPush [MR S.MW] for 1 sec. to enter the select memory
write condition.
•1 short and 1 long beeps sound.
• Displays the original memory channel number automatically and
“
µµ
” indicator blinks.
•Do not hold [MR S.MW] for more than 2 sec., otherwise the
memory contents will be copied to VFO.
ePush [8 SET] once to select “BANK.”
• While pushing [8 SET] then rotate [R-DIAL] also selectable
“BANK.”
rWhile pushing [BAND], rotate [R-DIAL] to select the de-
sired bank group to be transfer.
• Select “– – – –” indication when erasing the contents from the
bank.
tRotate [R-DIAL] to select the desired bank channel.
yPush [MR S.MW] for 1 sec.
To Next Page
Loading...
