VII
QUICK REFERENCE GUIDE
■ Programmed scan operation
25 pairs, 50 channels of memories are used for programmed
scan operation, that specify a scanning range. The pro-
grammed scan scans between “xxA” and “xxB” (xx=00 to 24)
frequencies. Therefore, before operating the programmed
scan, different frequencies must be programmed into “A” and
“B” channels.
DD
Programming scan edges
Astart frequency must be programmed into a “xxA,” and end
frequency must be programmed into a “xxB” memory channel.
1. Setting frequency
In VFO mode, set the desired receive frequency mode.
• When “
µµ
” indicator is displayed, push [VFO MHz] to select the
VFO mode.
2. Selecting a scan edge
channel “A”
Push [MR S.MW] for 1 sec.,
then
rotate [R-DIAL] to select one of
the desired scan edge channel
“A.”
•“
µµ
” indicator blinks.
3. Writing a memory channel
Push [MR S.MW] for 1 sec. until
3 beeps sound.
• Scan edge channel “B” is automat-
ically selected when continuing to
push [MR S.MW] after program-
ming.
• After programming is completed,
return to VFO indication.
4. Selecting a scan edge
channel “B”
Push [MR S.MW] for 1 sec.,
then ro-
tate [R-DIAL] to select one of the
desired scan edge channel “B.”
•“
µµ
” indicator blinks.
• When the scan edge channel “B” is al-
ready selected at step 3. (continuing to
push [MR S.MW] after programming),
skip this step.
5. Writing a memory channel
Push [MR S.MW] for 1 sec. until 3 beeps sound.
• The next scan edge channel “A” is automatically selected when con-
tinuing to push [MR S.MW] after programming.
• After programming is completed, return to VFO indication.
To Next Page
Loading...
