Icom IC-V80 User Manual

53
D VOX-related settings
The VOX gain, the VOX delay, and the VOX time-out timer can
be set in the Set mode.
q Connect an optional headset and plug adapter cable to
the transceiver, and then turn the power ON.
w Push [FUNC](M), and then [VOX](2) to turn the VOX func-
tion ON.
e Push [FUNC](M), and then [SET](8) to enter the Set mode.
r Push [] or [] to select the VOX gain (VOX), the VOX
delay (VXd), or the VOX time-out timer (Vto) item.
t Rotate [VOL] to select a desired option.
y Push [# ENT] to exit the Set mode.
The VOX function does not activate transmission while in
the Set mode.
• VOX gain
The VOX gain level can be adjusted between 1 (minimum) and
10 (maximum), or turned OFF. Higher values make the VOX
function more sensitive to your voice.
(default: VOX.05)
➥ While speaking into the head-
set microphone, adjust the
VOX gain until “On” continu-
ously appears on the LCD.
If “On” is intermittent, be sure the VOX delay is set long
enough to allow normal pauses in speech, but keep the
VOX ON until you finish speaking.
✔ CONVENIENT!
While transmitting using the VOX function, you can adjust
the VOX gain simply by rotating [DIAL].
• VOX delay
Sets the VOX delay to between 0.5 and 3.0 sec. (in 0.5 sec.
steps). The VOX delay is the amount of time the transmitter
stays ON after you stop speaking. (default: VXd.10)
The VOX delay is set to
1 sec.
The VOX delay is set to
3 sec.
• VOX time-out timer
Sets the VOX time-out timer to between 1, 2, 3, 4, 5, 10 and
15 min. to prevent accidental prolonged transmission for the
VOX function.
To turn the function OFF, select “Vto.OF.” (default: Vto.03)
14
OPTIONS
The VOX function is
turned OFF.
The VOX gain is set to
10 (maximum).
Appears

Icom IC-V80 Specifications

General

Frequency Range	136-174 MHz
Mode	FM
Waterproof	IP54
Dimensions	58 x 112 x 30 mm
Operating Voltage	7.2 V DC
Channels	207 (200 memory channels, 6 scan edges, and 1 call channel)