Icom VHF IC-F50

8
2
PANEL DESCRIPTION
2
C.TONE CHANNEL ENTER KEY
Selectthecontinuoustonechannelusing[CHUp]/[CHDown]keys
to change the tone frequency/code setting after pushing this key for
permanent operation.
TALK AROUND KEY
Turn the talk around function ON and OFF.
•Thetalkaroundfunctionequalizesthetransmitfrequencytothere-
ceive frequency for transceiver-to-transceiver communication.
WIDE/NARROW KEY
Push to toggle the IF bandwidth between wide and narrow.
•Thewidepassbandwidthcanbeselectedfrom25.0or20.0kHzusing
theCS-F50c l o n i n g s o f t w a r e .(PMRorBIISPMRoperationonly)
Ask your dealer for details.
DTMF AUTODIAL KEY
➥ Push to enter the DTMF
channel selection mode. Then select
thedesiredDTMFchannelusing[CHUp]/[CHDown]keys.
➥ After selecting the desired DTMF channel, push this key to trans-
mit the DTMF code.
DTMF RE-DIAL KEY
Push to transmit the last-transmitted DTMF code.
CALL KEYS
Pushtotransmita2/5-tone/BIISIDcode.
•Calltransmissionisnecessarybeforeyoucallanotherstationdepend-
ing on your signalling system.
•The[CallA]and/or[CallB]keysmaybeavailablewhenyoursystem
employs selective ‘Individual/Group’ calls. Ask your dealer which call
is assigned to each key.