Icom VHF IC-F50

9
2
PANEL DESCRIPTION
EMERGENCY KEYS
➥ Push and hold to transmit an emergency call.
➥When[EmergencySingle(Silent)]or[EmergencyRepeat(Si-
lent)]ispushed,anemergencycallistransmittedwithoutabeep
emission and LCD indication change.
 •Ifyouwanttocanceltheemergencycall,push(orpushandhold)
the key again before transmitting the call.
 •Theemergencycallistransmittedonetimeonlyorrepeatedlyuntil
receiving a control code depending on the pre-setting.
TX CODE ENTER KEY (PMRorBIISPMRoperationonly)
Push to enter the direct ID code edit mode, for both 5-tone and
MSK.Then set the desired digit using [CH Up]/[CH Down]/
[TXCodeCHUp]/[TXCodeCHDown].(p.16)
TX CODE CHANNEL SELECT KEY
➥ Push to enter the direct ID code channel selection mode. Then
setthedesiredchannelusing[CHUp]/[CHDown]/[TXCodeCH
Up]/[TXCodeCHDown].(p.15)
➥ While in ID code channel selection mode, push for 1 sec. to enter
the ID code edit mode for 5-tone and MSK. Then set the desired
digitusing[CHUp]/[CHDown]/[TXCodeCHUp]/[TXCodeCH
Down].(p.16)
TX CODE CHANNEL UP/DOWN KEYS
Push to select a TX code channel directly.
ID MEMORY READ KEY (PMRorBIISPMRoperationonly)
➥ Recalls detected ID codes.
 •Pushthiskey,thenpush[CHUp]/[CHDown]forselection.
 •Upto5ID’sarememorized.
➥ Push and hold to erase the selected memorized ID’s.