FC6A S
ERIES
M
ICRO
S
MART
A
LL
-
IN
-O
NE
T
YPE
U
SER
’
S
M
ANUAL
FC9Y-B1722 2-77
2: P
RODUCT
S
PECIFICATIONS
(5) Auto Tuning/auto Reset LEDs [AT0, AT1]
Flashing: When executing auto tuning or auto reset
Off: When auto tuning or auto reset is stopped
(6) Manual Mode LEDs [MT0, MT1]
On: When program control mode is selected
Off: When auto mode is selected
(7) Fixed Value Control Mode/program Control Mode LEDs [F/P0, F/P1]
On: During program control mode
Off: During fixed value control mode
(8) Program Control Execution/hold LEDs [R/H0, R/H1]
On: During program control execution or while control is allowed in fixed value control
Flashing: When there is a power interruption during program control hold or during program control execution
Off: During program control stopped or while control prohibited in fixed value control
(9) External SP Enabled/disabled LEDs [R/L]
On: External SP input is enabled
Off: External SP input is disabled
(10) Terminal Name Label
Indicates terminal numbers.
(11) Cable terminals
These terminals are for connecting cables. Terminal block type (3.81 mm pitch), spring clamp system.
(12) Expansion connector
Connects the expansion modules and the CPU module.
Model List
Module type Cable Terminal Type I/O Points I/O Signal Type No.
Non-contact voltage output
(to drive SSRs)/current
output type
Terminal block type
(3.81 mm pitch)
Input 2
Voltage input (0 to 10 V, 0 to 5 V, 1 to 5 V, 0 to 1 V)
Current input (4 to 20 mA, 0 to 20 mA)
Thermocouple (K, J, R, S, B, E, T, N, PL-II, C)
Resistance thermometer (Pt100, jPt100)
FC6A-F2M1
Output 2
Voltage output (12V DC digital output)
Current output (4 to 20 mA)
Relay contact output type
Terminal block type
(3.81 mm pitch)
Input 2
Voltage input (0 to 10 V, 0 to 5 V, 1 to 5 V, 0 to 1 V)
Current input (4 to 20 mA, 0 to 20 mA)
Thermocouple (K, J, R, S, B, E, T, N, PL-II, C)
Resistance thermometer (Pt100, jPt100)
FC6A-F2MR1
Output 2 Relay output
To Next Page
Loading...