7: HMI F
UNCTION
7-16 FC6A S
ERIES
M
ICRO
S
MART
A
LL
-
IN
-O
NE
T
YPE
U
SER
’
S
M
ANUAL
FC9Y-B1722
6. Select Setting with the (up) and (down) buttons and press the (OK) button.
7. With the (up) and (down) buttons, select ON or OFF.
Notes:
• If you specify Data Register, the network settings cannot be configured because they are acquired from the data registers.
• The current network settings can be checked from the status monitor.
8. Press the (OK) button to change the CPU module's DHCP setting and to display the CPU Network Settings 1 screen.
Next, to change the IP address, subnet mask, gateway, preferred DNS server, and alternate DNS server, see the following pages.
• "Changing the IP address" on page 7-17, from step 2
• "Changing the subnet mask" on page 7-18, from step 2
• "Changing the gateway" on page 7-25, from step 2
• "Changing the preferred DNS server" on page 7-20, from step 2
• "Changing the alternate DNS server" on page 7-21, from step 2
9.
Press the (ESC) button to display the screen in the following diagram. Select Yes with the (down) button and press the
(OK) button.
Setting: Fixed
IP Address
192.168. 1. 5
CPU Network Settings
Setting:
Fixed
Data Register:
DHCP
Setting: Fixed
IP Address
192.168. 1. 5
CPU Network Settings
Do you want to
configure network?
No
Yes
To Next Page
Loading...