idp SOLID Series - Page 67

67
-. Check the state of the Cable between a module and a main board
-. Check the operating state of the IC Motor
7
Ribbon Seek Err
The printer can’t search the ribbon panel in printing or booting up
-. Check the operating state of the Ribbon Motor
-. Check the operating state of the ribbon encoder sensor and gears
-. Check and clean the Color In/Out Sensor
-. Check the operating state of the color in/out Sensor
8
Ribbon Move Err
The printer can’t wind the ribbon in printing or booting up.
-. Check the operating state of the Ribbon Motor
-. Check the operating state of the ribbon encoder sensor and gears
9
MAG R/W Error
Fail to read or write the magnetic stripe.
-. Check the surface and direction of magnetic card
-. Check the coercivity of magnetic card and encoding configuration
-. Check the rollers, encoder and cards, and clean them if they are polluted
10
MAG T1 Error
Fail to read a track 1 of the magnetic stripe.
-. Check the surface and direction of magnetic card
-. Check the coercivity of magnetic card and encoding configuration
-. Check the rollers, encoder and cards, and clean them if they are polluted
11
MAG T2 Error
Fail to read a track 2 of the magnetic stripe.
-. Check the surface and direction of magnetic card
-. Check the coercivity of magnetic card and encoding configuration
-. Check the rollers, encoder and cards, and clean them if they are polluted
12
MAG T3 Error
Fail to read a track 3 of the magnetic stripe.
-. Check the surface and direction of magnetic card
-. Check the coercivity of magnetic card and encoding configuration
-. Check the rollers, encoder and cards, and clean them if they are polluted
13
Printing Error
Error occurs while printing
-. Check a card is jammed
-. Check usage of a genuine ribbon and cards