idp SOLID Series - Page 68

68
-. Check the rollers, encoders and cards, and clean them if they are polluted
14
Init Error
Error occurs while initializing
-. Check the status of installation of ribbon and laminating film
-. Check the laminator turning on if the laminator is installed
15
DeviceCon Error
Fail to communicate between a printer and a flipper/laminator
-. Check the laminator turning on if the laminator is installed
-. Check a cable between a printer and a flipper/laminator
16
Lami Error
Error occurs while laminating
-. Remove a card after opening a laminator top cover
-. Check usage of a genuine laminating film and cards
17
Flipper Error
Error occurs while operating a flipper
-. Remove a card after opening a flipper cover
-. Check the card size
18
Ribbon Zero
All ribbons are used
-. Install the new ribbon after purchasing it in the place of purchase
19
RibbonNotFound
Ribbon is not installed or not searched
-. Install a ribbon if not
-. Check usage of a genuine ribbon
20
TPH Not Found
Thermal Print Head is not installed or not recognized
-. Check the print head installation
-. Contact the place of purchase
21
TPH Over Heat
Thermal Print Head is overheated
-. Lower the temperature when the temperature of circumstance is too high
-. Take a stop for 10 minutes and print again.
-. Contact the place of purchase if this message is shown regularly
22
Invalid Data
Error occurs when the abnormal printing data is transmitted.
-. Replace the USB cable USB
-. Change the USB port in the PC
-. Reinstall the printer driver