IFM AC1421 - Download the Application to the Device; Delete Application from AS-I Gateway AC14

50
ifm Programming Manual AS-i Gateway AC14 (4.2.x) 12/2017
Operation Transfer CODESYS project to device
>
8.1.2 Download the application to the device
18593
To transfer the created application as boot project to the device:
Requirements:
> Network path is set (→ Set communication path to PLC (→ p. 20)).
> Project tested.
> All ifm system solutions stored on the devie are deleted (→ device manual: Uninstall ifm apps)
1 Build application
► In the device tree: Highlightt application as active application.
► Use [Build] > [Rebuild] to compile the active application.
> CODESYS generates program code.
2 Load application on the device
► Use [Online] > [Login] to connect with the device.
> Active application is transfered to the device (download).
> application on the device is in STOP state.
3 Create boot application
► Use [Online] > [Create boot application] to make the application bootable.
> application storage is non-volatile.
4 Start boot application
► Use [Debug] > [Start] to start the application.
> application goes to the RUN state.
>
8.1.3 Delete application from AS-i Gateway AC14
18030
To delete an application stored on the device:
1 Connect with the device
► In the device tree: highlight application as active application.
► Use [Online] > [Login] to establish connection to the device.
> CODESYS is in the online mode.
2 Delete application
► In the editor window: Select [Device] > [Applications] tab.
► Press [Refresh List] to refresh the view.
> List shows the applications that are stored on the device.
► Delete all applications in the device with [Remove All].
OR:
Highlight requested application and press [Remove] to delete it from the device.
> Selected application will be deleted.