IFM AC1421 - Switch Operating States

53
ifm Programming Manual AS-i Gateway AC14 (4.2.x) 12/2017
Operation Operating states of the PLC
>
8.2.3 Switch operating states
10264
To switch between the operating states of the application choose one of the following options:
>
Start PLC application
18027
To start a PLC application stored on the device:
 CODESYS:
► In the device tree: highlight application as active application.
► Use [Online] > [Login] to establish the connection with the CODESYS PLC.
► Use [Debug] > [Start] to start the processing of the active application.
> Application goes to RUN state.
► Optional: repeat process for additional applications.
 GUI / web interface:
► > >
► Select the [Applications] tab.
► Use [] / [] to select the required application.
> Page shows the operating status of the selected application.
► Press [Start] function key to start the processing of the selected application.
> Application goes to RUN state.
► Optional: repeat process for additional applications.
>
Stop PLC application
18029
To stop a PLC application stored on the device:
 CODESYS:
► In the device tree: highlight application as active application.
► Use [Online] > [Login] to establish the connection with the CODESYS PLC.
► Use [Debug] > [Stop] to stop the processing of the active application.
> Application goes to STOP state.
► Optional: repeat process for additional applications.
 GUI / web interface:
► > >
► Select [Applications] tab.
► Use [] / [] to select the required application.
> Page shows the operating status of the selected application.
► Press [Stop] function key to stop the processing of the selected application.
> Application goes to STOP state.
► Optional: repeat process for additional applications.