ILX Lightwave LDC-3700 Series User Manual

LDC-3700 Series Laser Diode Controller ERROR MESSAGES
Error Code
E-OO 1
E-101
E-102
E-103
E-
104
E- 105
E-106
E-107
E-108
E-109
E-110
E-1 I1
E-113
E-114
E-115
E-116
E- 120
E-I21
E-122
E-123
E- l2-I
E-125
E-126
E-'0 1
E-202
E-203
E-204
E-105
E-Zoo
E-207
E-208
E-209
E-2
10
E-2 1 1
E-2 12
E-2 1 i
E-2 14
Ennlanation
Memory allocation failure.
<program mnemonic> is too long.
<PROGRAM MESSAGE
UNIT> is too long.
<DEFINITE LENGTH
ARBITRARY BLOCK PROGRAM DATA> length too long.
<NON-DECIMAL
NUMERIC PROGRAM DATA> type not defined.
<DECIMAL PROGRAM DATA> exponent not valid.
<DECIMAL PROGRAM DATA> digit expected.
<DECIMAL PROGRAM DATA> hgit not expected.
<DECIMAL PROGRAM DATA> more
than one decimal point.
<DECIMAL PROGRAM DATA> more than one exponential indcator
(E).
<SUFFIX PROGRAM DATA> must have digit following sign.
<SUFFIX PROGRAM DATA> must have alpha character following operator.
<ARBITRARY BLOCK PROGRAM DATA> length less than digit count.
<DEFINITE LENGTH BLOCK PROGRAM DATA> premature end of
data.
<PLACEHOLDER PROGRAM DATA> identifier not valid.
Parser syntax error, character was not expected.
<program mnemonic> Lookup, word as part of a header path, has no commands.
<program mnemonic> Lookup, word as part of a header path, is not found.
<program mnemonic> Lookup, cannot find a null entry.
<program mnemonic> Lookup, word
withm context of current path, is not found.
<program mnemonic> Lookup, failed because query/cornmand
type match failed.
<program mnemonic> Lookup, word within context of common command path, is not found
Too
few or too many program data elements.
<PROGRAM DATA> value out of range.
<PROGRAM DATA> will not convert to valid type.
Sccuri8 violation, command is not available without clearance.
<PROGRAM DATA> suffix
type is not valid.
<PROGRAM DATA> is not a boolean value or word.
<PROGRAM DATA> will not convert to
a signed 16-bit value.
<PROGRAM DATA> will not convert to
an unsigned 16-bit value.
<PROGRAM DATA> will not convert to a signed 32-bit value.
<PROGRAM
DATA> will not convert to an unsigned 32-bit value.
<PROGRAM
DATA> will not convert to a floating point value.
<PROGRAM
DATA> will not convert to a character value.
<PROGRAM DATA> will not convert to a byte array pointer.
<PROGRAM
DATA> is incorrect block
data length.
<PROGRAM DATA> length exceeds maximum.
Table D.2 LDC-3700 Series Laser Diode Controller Error Message Codes
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English