ILX Lightwave LDC-3700 Series User Manual

3.4.20 *TST?
The Self-Test query causes an internal self-test and returns a response when the self-test is complete. The syntax of
the TST? query
is:
The response is <DECIMAL NUMERIC RESPONSE DATA>, where the value of the response is 0 if the self-test
completes with no errors.
If the response is a value other than 0, the self-test was not completed or it was
completed with errors detected.
The Wait-to-Continue command prevents the LDC-3700
Series Laser Diode Controller from executing any further
commands
until the No-Operation-Pending flag is true. This allows the programmer to make the LDC-3700 Series
Laser Diode Controller wait for the completion of an operation before continuing. For more information on the
operation complete
(OPC) flag, see section 3.7.2.
The syntax for the *WAI command is:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English