Imaje S8 Classic - Page 90

88 A20733 B0
Servicing
3.2.5 Restarting the printer after manual rinsing
Draining:
With the printer stopped, drain the ink tank, viscometer circuit (viscometer and constant
level tube) and the main filter (leave the filter cartridge in place).
Use the cleaning solution spray bottle to spray the inside of the ink tank to remove traces of
ink as far as possible from the basket at the bottom of the tank and in the constant level tube.
Leave to drain completely.
Replacing the ink filter cartridge:
Open the main filter, remove the old cartridge, thoroughly clean the inside of the casing
with fresh cleaning solution, fit a new filter cartridge and reassemble the filter.
Refilling with ink:
After replacing all the drain plugs, fill the ink tank with one liter of ink.
Check the additive level.
Start the printer, checking that the ink jet is present and stable.
- It may be necessary to use the [Stability] function.
- It is essential to use the [Refresh] function for 5 minutes.
Rinsing the entire ink circuit:
After replacing the drain plugs, pour one liter of cleaning solution into the ink tank.
Start the printer and enable the refresh function for 20 minutes.
For a shutdown of less than three months: For a shutdown of more than three months:
The procedure involves three phases: The procedure involves five phases:
1) Drain. 1) Drain.
2) Change the filter cartridge. 2) Completely rinse the ink cartridge.
3) Refill with ink. 3) Drain.
4) Change the filter cartridge.
5) Refill with ink.