Indutherm CC3000 - Page 52

Operation
TechDoku_CC1000_VCC1000_CC3000_VCC3000_GenPM_GB_860
25010_86025110.doc
7-20
Test report:
Material: silver 935 melting point: 904 °C
Die temperature at the beginning of the drawing process for all tests:
approx. 600 °C.
Drawing length at the beginning of the drawing process is for all tests: 2 mm.
Form
wire  6 mm
sheet 40 * 5 mm
tube 18 mm/12 mm
Casting temp. in °C
1050
1050
1150
Drawing length in mm
5
2
2
Die temperature in °C
600
600
600
Note:
At our webpage www.INDUTHERM.de you’ll find a train-
ing video of former model CC3000 with P-generator.
Recommendation INDUTHERM:
Before you do your first drawing with your material let
run the test program 18 at room temperature with cold
starter bar.