Operating
Adjusting the projector’s elevator
When the location where the projector is being placed is
slightly uneven to the left or right, use the elevator feet
to help level the projector horizontally.
Using the feet, you can also tilt the projector to project to
a suitable angle to the screen, elevating the front side of
the projector up to 12 degrees.
This projector has 2 elevator feet and 2 elevator buttons.
An elevator foot can be adjusted when you push the
elevator button on the same side as it.
To loosen an
elevator foot, push
the elevator button
on the same side
as it.
For ne
adjustments,
twist the foot.
1.
Holding the projector, push the elevator buttons to
loosen the elevator feet.
2.
Position the front side of the projector to the desired
height.
3.
Release the elevator buttons in order to lock the
elevator feet.
4.
After making sure that the elevator feet are locked,
put the projector down gently.
5.
If necessary, the elevator feet can be manually
twisted to make more precise adjustments. Hold the
projector when twisting the feet.
►Do not handle the elevator buttons without holding the
projector, since the projector can fall down.
►Do not tilt the projector except by elevating its front with the adjuster feet up
to 12 degrees. Tilting the projector more than this could cause a malfunction or
shorten the lifetime of the projector or projector consumables.
CAUTION
To Next Page
Loading...
Need help?
General
Weight and Dimensions
