Introduction
Part names
Projector
(1) Lamp cover ( 82)
The lamp unit is inside.
(2) Speakers (x2) (13, 41)
(3) Filter cover (86)
The air lter and intake vent are inside.
(4) Elevator feet (x2) (20)
(5) Elevator buttons (x2) (20)
(6) Remote sensor (15)
(7) Lens (86)
(8) Lens cover
(9) Intake vents
(10) Control panel (5)
(11) Lens adjuster door (5)
The adjusters for the lens are behind
the door.
(12) AC IN (AC inlet) (14)
(13) Exhaust vent
(14) Rear panel (5)
(15) Security bar (14)
(16) Heel
►Do not open or remove any portion of the product, unless the
manuals direct it.
►Do not subject the projector to unstable conditions.
►Do not shock or apply pressure to this product.
►Do not look into the lens or openings of the projector when the lamp is on.
►Keep the lens cap away from children and pets. Make sure they do not
swallow the caps. If swallowed consult a physician immediately for emergency
treatment.
WARNING
►Do not touch the projector anywhere around the lamp
cover or the exhaust vents during use or just after use, since it is too hot.
►Do not attach anything onto the lens except the projector’s lens cover
because it could melt or otherwise damage the lens.
CAUTION
(continued on next page)