Item Description
VERTICAL
POSITION
Using the ◄/► buttons adjusts the vertical position.
Down
ó
Up
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs, please reset the vertical position to its
default setting.
• When this feature is performed on a video signal or an S-video
signal, the range of this adjustment depends on OVERSCAN (
33)
setting. When OVERSCAN is set to 10, you cannot adjust this
feature.
•
This feature is not available for LAN, USB TYPE A, USB TYPE B
or HDMI port input signals.
HORIZONTAL
POSITION
Using the ◄/► buttons adjusts the horizontal position.
Right
ó
Left
•
Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs, please reset the horizontal position to its
default setting.
• When this feature is performed on a video signal or an S-video
signal, the range of this adjustment depends on OVERSCAN (
33)
setting. When OVERSCAN is set to 10, you cannot adjust this
feature.
• This feature is not available for LAN, USB TYPE A, USB TYPE B
or HDMI port input signals
(continued on next page)
To Next Page
Loading...
