InFocus IN5132c User Manual

10
Setting up
Connecting your devices
Before connecting the projector to a device, consult the device manual to
conrm that the device is compatible with this projector and prepare the required
accessories, such as appropriate cables. Contact your dealer when the required
accessory did not come with the product or an accessory is damaged.
After verifying that the projector and the devices are turned off, make all
connections per the following instructions. Refer to the illustrations on the
subsequent pages. Before connecting the projector to a network system, be sure
to read Network Guide too.
►Use only compatible accessories. Otherwise a re or damage may occur to
the projector and devices.
• Only use accessories specied and recommended by the
projector’s manufacturer. Some regulations may apply.
• Do not disassemble or modify the projector or its accessories.
• Do not use damaged accessories. Be careful not to damage the accessories.
Route cables so that they cannot be stepped on or pinched.
►For a cable with a core at only one end, connect the end with the core to
the projector. That may be required by EMI regulations.
WARNING
• Do not turn the projector on or off while connected to a device
in operation, unless specied by the device manual. Otherwise a device or
projector malfunction may occur.
CAUTION
• Plug-and-Play is a system composed of a computer, its operating system
and peripheral equipment (i.e. display devices). This projector is VESA DDC
2B compatible. Plug-and-Play can be used by connecting this projector to a
computer that is VESA DDC (display data channel) compatible.
- Take advantage of this feature by connecting a computer cable to the
COMPUTER IN1 port (DDC 2B compatible). Plug-and-Play may not work
properly if any other type of connection is attempted.
- Use standard drivers in your computer as this projector is a Plug-and-Play
monitor.
• Some input port functions can be selected based on your usage
requirements. Check the reference page indicated beside each port in the
following illustration.
• Be careful not connect a connector to a wrong port. Otherwise a device or
projector malfunction may occur.
- When connecting a connector to a port, make sure that the shape of the
connector ts the port.
- Tighten the screws to connect a connector equipped with screws to a port.
- Use cables with straight plugs, not L-shaped ones, as the input ports of the
projector are recessed.
About Plug-and-Play capability
NOTE
(continued on next page)

InFocus IN5132c Specifications

General

Brand	InFocus
Model	IN5132c
Category	Projector
Language	English