25
Operating
Operating
1.
Adjusting the volume
Use the VOL + / - buttons to adjust the volume.
A dialog will appear on the screen to aid you in
adjusting the volume. If you do not do anything,
the dialog will automatically disappear after a few
seconds.
•
When is selected for current source, the volume adjustment is
disabled. See the AUDIO SOURCE item of AUDIO menu (57).
• Even if the projector is in standby mode, the volume is adjustable when both
of the following conditions are true:
- An option other than is selected for AUDIO OUT STANDBY in the AUDIO
SOURCE item of the AUDIO menu (57).
- NORMAL is selected in the STANDBY
MODE item of the SETUP menu
(56).
1.
Press AV MUTE button on the remote control.
The BLANK screen will be displayed instead of
the source image and the internal speakers will be
muted. Refer to the BLANK item in SCREEN menu
to learn about the BLANK screen (59).
To exit from AV MUTE mode and restore the screen
and audio, press AV MUTE button again.
Turning off the source image and audio temporarily
►If you wish to have a blank screen while the projector's lamp
is on, use the AV MUTE function above or the lens shutter function (36). Any
other action may damage the projector.
CAUTION
VOL + / -
buttons
AV MUTE
button
NOTE
• The projector automatically exits from AV MUTE mode when some
control buttons are pressed.
NOTE
To Next Page
Loading...
Need help?
General
