18
30°
3m
30°
30°
30°
3m
(approx.)
About the remote control signal
The remote control works with the
projector’s remote sensors. This
projector has two remote sensors on the
front and back sides.
The sensors can sense signals within
the following range:
60 degrees (30 degrees to the left and right of the
sensor) within approximately 3 meters.
• You can deactivate one of the sensors using the REMOTE RECEIV.
item in the SERVICE menu of the OPTION menu (71).
• The remote control signal may be able to be reected off of the screen or
other item. If it is difcult to send the signal to the sensor directly, try reecting
the signal.
• The remote control uses infrared light to send signals to the projector (Class 1
LED), so be sure to use the remote control in an area free from obstacles that
could block the remote control’s signal to the projector.
• The remote control may not work correctly if strong light (such as direct
sun light) or light from an extremely close range (such as from an inverter
uorescent lamp) shines on the remote sensor of the projector. Adjust the
position of projector avoiding those lights.
NOTE
Changing the remote control signal frequency
There are two choices to control the signal frequency mode of the remote control,
Mode 1:NORMAL and Mode 2:HIGH. If the remote control does not function
properly, try changing its mode.
In order to set the Mode, press and hold the two button combination listed below
for about 3 seconds.
(1) To s et Mode 1:NORMAL
AV MUTE and ZOOM buttons
(2) To set Mode 2:HIGH
F5 and KEYSTONE buttons
Remember to use the same mode
for the projector's REMOTE FREQ. in the SERVICE item of the OPTION menu
(
71)
.
Remote control
(1)
ZOOM -
button
AV MUTE
button
(2)
KEYSTONE
button
F5
button
To Next Page
Loading...
Need help?
General
