16
Connecting a power supply
1.
Plug the power cord into the projector's AC
IN (AC inlet).
2.
Firmly plug the power cord’s plug into a
power outlet. After a few seconds, the
POWER indicator will light steady orange.
►Do not connect the projector to a power supply when no lens
unit is attached to it.
►Use extra caution when connecting the power cord, as incorrect or faulty
connections may result in re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched with the
power cord. The power outlet should be close to the projector and easily
accessible. Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in re, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
• This product is also designed for IT power systems with a phase-
tophase voltage of 220 to 240 V.
WARNING
Remember that when the DIRECT POWER ON
function activated (66), the power supply connection
will make the projector turn on.
NOTICE
Setting up
AC IN
Power
cord
To Next Page
Loading...
Need help?
General
