InFocus IN5132c User Manual

115
Troubleshooting
Regarding the indicator lamps
When the LAMP, TEMP and POWER indicators are acting unusual, review the
following table.
POWER
indicator
LAMP
indicator
TEMP
indicator
Description
Solid
Orange
OFF OFF
The projector is in a standby state.
Refer to the section “Power on/off”.
Blinking
Green
OFF OFF
The projector is warming up.
Please wait.
Solid
Green
OFF OFF
The projector is in an ON state.
Normal operations can be performed.
Blinking
Orange
OFF OFF
The projector is cooling down.
Please wait.
Blinking
Red
(discre-
tionary)
(discre-
tionary)
The projector is cooling down. An error has
been detected.
Please wait until the
POWER
indicator nishes
blinking, and then follow the directions below.
Blinking
or
Solid
Red
Solid
Red
OFF
The lamp does not light, and the inside of the
projector may be overheated.
Turn the power off, and allow the projector to cool
down at least 20 minutes. After the projector has
cooled down sufciently, verify the following items,
and then turn the power on again.
• Are the vents blocked?
• Is the air lter dirty?
• Does the peripheral temperature exceed 45°C?
• If you are using an
IN5132
,
IN5134
,
IN5134a
or
IN5135
, does the peripheral temperature exceed
40°C?
If indicators are doing the same thing, change the
lamp according to section
Replacing the lamp
.
Blinking
or
Solid
Red
Blinking
Red
OFF
The lamp cover has not been securely
fastened.
Turn the power off, and allow the projector to cool
down at least 45 minutes. After the projector has
cooled down sufciently, verify the attachment state
of the lamp cover. After performing any needed
maintenance, turn the power on again. If the
indicators are doing the same thing, contact your
dealer or service company.
(continued on next page)

InFocus IN5132c Specifications

General

Brand	InFocus
Model	IN5132c
Category	Projector
Language	English