76
NETWORK menu
Remember that incorrect network settings on this
projector may cause network problems. Contact your
network administrator before connecting to an existing
access point on the network.
Select “NETWORK” from the main menu to access the
following functions.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button on the projector or
remote control, or the ENTER button on the remote control to perform this item.
Then follow the instructions below.
See the Network Guide for more details about NETWORK operation.
NETWORK menu
• To use the wireless network function of this projector, the optional
specied USB wireless adapter is required. Do not use any extension cables or
devices when connecting the adapter to the projector.
• Wired and wireless LAN cannot be connected to the projector using the same
network simultaneously.
• Do not dene the same network address for both wireless and wired LAN.
• If you are not utilizing SNTP (3.1.8 Date/Time Settings in the Network
Guide), DATE AND TIME must be dened during the initial installation.
•When the STANDBY MODE in the SETUP menu is set to SAVING and the
projector is in standby mode, the network communication control is disabled.
Connect the network communication to the projector after setting STANDBY
MODE to NORMAL (
56
).
NOTE
Item Description
WIRELESS
SETUP
Select this to display the WIRELESS
SETUP menu for the wireless LAN.
Use the ▲/▼ buttons to select an item,
and the ► or ENTER button on the remote
control to perform the item.
MODE
Use the ▲/▼ buttons to select the network
communication system mode. Select the item
based on your computer settings.
AD HOC
ó
INFRASTRUCTURE
To save the setting, press the ► button.
• When ADHOC is selected, IEEE802.11 n cannot
be used.
• When ADHOC is set to MODE, ENCRYPTION
(
78
) switches to OFF automatically.
(continued on next page)
To Next Page
Loading...
Need help?
General
