InFocus LP500 - Parts Lists; Frus by Alphabetic Listing

LP500 Series Service Manual 113
Parts Lists
FRUs by alphabetic listing
Below is an alphabetically arranged list of FRUs used in the LP500 and LP530 projectors. You can also
view FRUs by numeric listing (see page 116).
Part Name Projector Part Number Notes
Bottom case Both 505-0836-xx Includes leveling foot, rubber foot, elevator, light
block louver and engine mount spacer.
Chassis Both 330-0702-xx
Controller ECA LP500 510-1579-xx
Controller ECA LP530 510-1530-xx
Controller/power supply
cable
Both 211-0161-xx
Diode heat sink bracket Both 330-0742-xx Also requires gap pad (329-0301-xx). Fits
between the chassis and the bottom of the power
supply.
Elevator lever Both 340-0822-xx
Elevator shaft Both 505-0878-xx
Elevator spring Both 321-0170-xx
Engine mount spacer Both 340-0837-xx
Fastener Kit Both 802-0027-xx Includes all fasteners necessary to attach each
FRU in the LP500/530 projector.
Focus ring Both 505-0840-xx
Front bezel Both 505-0959-xx
Front bezel vent Both 505-0961-xx
Gap pad, rear diode Both 329-0301-xx Adheres to diode heat sink bracket
Gap pad, front diode Both 329-0302-xx Adheres to the chassis
Ground clip Both 330-0724-xx Fastens to the chassis. Grounds to the optical
engine.
I/O EMI shield Both 330-0703-xx
IR cable Both 526-0094-xx
IR lens, rear Both 340-0851-xx Snaps into rear bezel.
IR lens, top Both 340-0886-xx Snaps into top case.