InFocus LP500 Service Guide

LP500 Series Service Manual 21
Assembly Notes
♦ If you're replacing the top case with a new one, install the keypad on the inside of the case (see page
22).
♦ Adhere a new InFocus nameplate to the top case in the recess near the IR window.
♦ Connect the keypad and IR cables first. Then engage the hinges on the lens side of the projector.
♦ Swing the top case shut, making sure that it fits flush over the bottom case.
♦ Torque the black M3x48 cone point Torx screw to 4 in.-lbs. (.452 Nm)

InFocus LP500 Specifications

General

Brand	InFocus
Model	LP500
Category	Projector
Language	English