Ingenico iCT250 - Page 50

SKYZER TECHNOLOGIES PAGE 50 OF 116
NITRO INGENICO ICT250 AND IWL252 2015 PAYMARK SOFTWARE OPERATING GUIDE Version 1.0
7.0
PABX?
1A
or
1W
Press ENTER to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note: The terminal pauses for 1 second after dialling if a control character ‘A’ is
inserted or to pauses for couple of seconds after dialling if a control character ‘W’ is
inserted after the PABX number. To insert a control character ‘A’ or ‘W’, press the
corresponding number key and then the FUNC key.
To remove a PABX number from the PABX field, press 1 and then press FUNC key
until space is displayed followed by ENTER.
8.0
HOST PHONE NO?
08797
This parameter specifies the phone number of Paymark network to dial to. By
default, the host phone number is set as 08797. Press ENTER.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
9.0
USE DNS Y/N
1-YES 2-NO
Press the corresponding number key and press ENTER to set for DNS or IP
Option 1 – to allow the terminal to use Paymark DNS address. Option 1 is
selected by default.
10.0
GPRS Primary
HOST DNS
gprs.paymark.co.nz
This parameter specifies the Paymark Primary DNS address. By default, it is set to
grps.paymark.co.nz. Press ENTER
11.0
GPRS Secondary
Host DNS
gprs2.paymark.co.nz
This parameter specifies the Paymark Secondary DNS address. By default, it is set
to gprs2.paymark.co.nz. Press ENTER
12.0
USE DNS Y/N
2-NO
Option 2 – to allow the terminal to use Paymark IP address.
13.0
GPRS Primary
HOST IP ADDRESS
117.120.35.3
This parameter specifies the GPRS Primary IP address. By default, it is set to
117.120.35.3. Press ENTER.
14.0
GPRS Secondary
HOST IP ADDRESS
117.120.33.3
This parameter specifies the GPRS Secondary IP Address. By default, it is set to
117.120.33.3. Press ENTER.
15.0
SAVE CONFIG Y/N
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or CLEAR to exit and return to idle screen.
16.0
START GPRS Y/N
Terminal prompts to start GPRS link. Press ENTER to start GPRS or CLEAR to exit
without starting GPRS link to Paymark.