Ingenico iCT250 User Manual

SKYZER TECHNOLOGIES PAGE 75 OF 116
NITRO INGENICO ICT250 AND IWL252 2015 PAYMARK SOFTWARE OPERATING GUIDE Version 1.0
8.1.2 GPRS Configuration
Step
Terminal Display
Comment
1.0
Press FUNC
2.0
FUNCTION?
Enter 2467 and press ENTER.
3.0
TMS CONFIG
ENTER OR CLEAR
Press ENTER to configure the TMS parameters, CLEAR to cancel and exit to idle
prompt.
4.0
TMS TERMINAL ID?
XXXXXXXX
This parameter specifies the TMS Terminal ID which is by default the last 8 digits of
the terminal serial number.
6.0
TMS NII
201
This parameter specifies the Network International Identifier that the terminal uses
to route messages to TMS.
Press ENTER.
7.0
TMS URL
www.skyzertms.co.n
z
This parameter specifies the TMS URL. By default is set to
www.skyzertms.co.nz.
Press ENTER.
8.0
PRIMARY
HOST IP ADDRESS
202.180.114.12
This parameter specifies the Primary Host IP Address. By default is set to
202.180.114.12.
Press ENTER.
9.0
PRIMARY
HOST PORT
3200
This parameter specifies the Primary Host Port number. By default is set to 3200.
Press ENTER.
10.0
APN?
paymarkfreedom.co.
nz
This parameter specifies the Access Point Name of the Paymark network or any
third party SIM card which has been configured for.
11.0
SAVE CONFIG Y/N
Press ENTER to save the configuration or CLEAR to exit without saving
configuration.

Ingenico iCT250 Specifications

General

Memory	16 MB RAM, 128 MB Flash
Card Readers	Magnetic stripe, Smart card, Contactless
Operating System	Telium 2
Connectivity	Ethernet
Security	PCI PTS 3.x certified
Printer	Integrated thermal printer
Supported Cards	Visa, Mastercard, American Express, Discover
Display	128x64 pixel LCD, Backlit
Power Supply	External power adapter