Ingenico iCT250 - Nitro Baud Rate Setup

SKYZER TECHNOLOGIES PAGE 56 OF 116
NITRO INGENICO ICT250 AND IWL252 2015 PAYMARK SOFTWARE OPERATING GUIDE Version 1.0
6.2 NITRO BAUD RATE SETUP
This function allows the merchant to set the different baud rate speed for Nitro
terminal to communication with POS system.
Perform the following steps to configure the baud rate on the terminal.
Step
Terminal Display
Description
1.0
NITRO
Press FUNC
2.0
FUNCTION?
Enter 84, press ENTER
3.0
NITRO BAUD RATE
1-9600
2-38400
3-115200
This parameter specifies the Nitro baud rate speed that the terminal can
communicate to POS system. By default, the baud rate speed is set to 9600.
To set the baud rate speed on the terminal, press the corresponding number key to
set the preferred baud rate speed.
Example: Press 2 to set the baud rate speed to 38400 or press 3 to set to
115200.
4.0
SAVE CHANGE Y/N
Terminal will prompt to save the changes made. Press ENTER to save the changes
or CLEAR to exit without save the changes made.
5.0
RESTART LINK Y/N
Terminal will prompt to restart the link to set the correct baud rate to communicate
with the POS system. Press ENTER to restart the link or CLEAR to exit without
restarting the link.